Re: [Xc3sprog-users] xc3sprog and Digilent "atlys" board?

[Joris v. R. <jor...@jo...>]

On 2012-12-03, Uwe Bonnes wrote:
>     Joris> The Atlys board also has an on-board JTAG-USB programmer
>     Joris> based on a Cypress FX2, but it uses a proprietary USB
>     Joris> protocol and therefore does not work with xc3sprog.
> 
> Did you try the the xpc cable? Perhaps it Digilent uses that cable?

Yes, I tried xpc and fx2 but they don't work.
I think their FX2 firmware is a Digilent-specific design.

It may be possible to adapt the XGUFF firmware to run on the FX2
chip on the Atlys board, but it is low on my list.

> Probably it is the same chip in the  csg324 and  fg484 package. If it
> works, it should be safe.

Ok, that makes sense.

Thanks, Joris.