Re: [Xc3sprog-users] Programming PROM

[Uwe B. <bo...@el...>]

>>>>> "Mark" == Mark de Jong <mar...@gm...> writes:
  
    Mark> Hello, I was wondering if anybody could help me with programming
    Mark> my Spartan-3 Starter Board with XC3S400 chip. Downloading a
    Mark> bitfile with xc3sprog on Ubuntu works great, but I was wondering
    Mark> if I did something wrong when downloading a .mcs file. 
    Mark The XCF02S
    Mark> PROM is in position 1, so I used the following command:

    Mark> xc3sprog -c pp -v -p 1 filename.mcs * * However, this gave all
    Mark> kinds of errors. Am I doing something wrong here?
    Mark> Any solution to
    Mark> get the program into the PROM would be great!

    Mark> Thanks in advance for all comments.

Post the relevant error messages, but try to minimize repetions.

-- 
Uwe Bonnes                bo...@el...

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------