SourceForge has been redesigned. Learn more.
Close

Word doc conversion with images

Anonymous
2000-12-01
2000-12-05
  • Anonymous

    Anonymous - 2000-12-01

    Hi,

    When I try to convert word document with some graphics included, I always get following messages (either on 0.6.2 or current CVS revision as of Nov. 30)

    wvWarning: There is no character run due to open but one should be, plugging the gap.
    wvError: (./wvWare.c:635) picture 0x01 here, at offset 0 in Data Stream, obj is 0, ole is 0

    Then the converted html file shows only the small part of the embedded image, because of the following html tag inserted:

    <p style="text-indent: -7.03mm; text-align: center; line-height: 6.250000mm.....
    <img width="xxx", height="yyy"....

    Is there any way I can fix this?

    B.T.W., there's no error/warning messages appered during compilation.

    ---
    Hiro-K

     
    • Anonymous

      Anonymous - 2000-12-05

      Hi,

      The message I posted last time was based on my misunderstanding. Although the warning messages as shown below still apears each time, the inserted tag seems to be correct. I misunderstood because Netscape 4.xx does not render CSS properly. I apologize for the inconvenience if my message caused any confusion.

      >wvWarning: There is no character run due to open but one should be, plugging the gap.

      >wvError: (./wvWare.c:635) picture 0x01 here, at offset 0 in Data Stream, obj is 0, ole is 0

      >Then the converted html file shows only the small part of the embedded image, because of the following html tag inserted:

      ><p style="text-indent: -7.03mm; text-align: center; line-height: 6.250000mm.....

      ><img width="xxx", height="yyy"....

      >Is there any way I can fix this?

       

Log in to post a comment.