[wsjt-devel] Problem with Release v2.7.0-rc8 (SteppIR control)

[Andy D. <a.d...@ms...>]

"In the 2.7 releases the rig moves to the correct frequency but the SteppIR does not. "

How is your SteppIR controller connected so that rig frequency is available to it?  There are many different ways of configuring this interface and it doubt it would be possible to investigate your problem without a lot more detail.

In my station, when using WSJT-X,  PstRotatorAZ receives rig frequency from DXLab Commander and PstRotatorAZ sends the frequency to my SDA 100 SteppIR controller.  Both the SDA 100 and PstRotatorAz can be set to control how much frequency change is needed for a new frequency to cause a change in SteppIR element length.

I have been using "v 2.7.1 devel 240721 improved PLUS" but I downloaded, installed, and ran the official 2.7.0.  My SteppIR tracks just the same as it did before.  Not surprising since WSJT-X has no interface to my SteppIR controller.

Andy, k3wyc