[Wirelessdriver-support] DWL-650

[Sal D. <smd...@ya...>]

Hi

  I am trying to get ml DWL-650 working on my PowerBook. The card does not
light up and I cannot get it recognized as a eth1 or eth2 card on my system. I
have installed and un-installed the drivers a few times with no success. I have
tried the manual command line entries but no luck.
If anyone can help me I would greatly appreciate it.

Thank You

Sal

### system info

ProductName:    Mac OS X
ProductVersion: 10.2.8
BuildVersion:   6R65
Darwin SalsComputer.local. 6.8 Darwin Kernel Version 6.8: Wed Sep 10 15:20:55
PDT 2003; root:xnu/xnu-344.49.obj~2/RELEASE_PPC  Power Macintosh powerpc
ppc7450

### wireless driver files installed

drwxr-xr-x    3 root   wheel    102 Sep 10 17:49 IOPCCardFamily.kext

### wirelesscard info


### network info

lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet6 ::1 prefixlen 128 
        inet 127.0.0.1 netmask 0xff000000 
gif0: flags=8010<POINTOPOINT,MULTICAST> mtu 1280
stf0: flags=0<> mtu 1280
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet6 fe80::20a:95ff:fe8c:553c%en0 prefixlen 64 scopeid 0x4 
        ether 00:0a:95:8c:55:3c 
        media: autoselect (none) status: inactive
        supported media: none autoselect 10baseT/UTP <half-duplex> 10baseT/UTP
<full-duplex> 10baseT/UTP <full-duplex,hw-loopback> 100baseTX <half-duplex>
100baseTX <full-duplex> 100baseTX <full-duplex,hw-loopback> 1000baseTX
<full-duplex> 1000baseTX <full-duplex,hw-loopback> 1000baseTX
<full-duplex,flow-control> 1000baseTX <full-duplex,flow-control,hw-loopback>
en1: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        inet6 fe80::230:65ff:fe2c:55c7%en1 prefixlen 64 scopeid 0x5 
        inet 192.168.0.232 netmask 0xffffff00 broadcast 192.168.0.255
        ether 00:30:65:2c:55:c7 
        media: autoselect status: active
        supported media: autoselect

### wd command line tool status

/Volumes/WirelessDriver beta 5.1/Utilities/Troubleshooting Info.command:
WirelessConfig: command not found
logout
[Process completed]