Re: [Wirelessdriver-support] network pane configuration

[Henry C. <ha...@in...>]

I was having the same "no en1 or en2" problem. I thought It was driver
related or some other issue until I just did the most obvious thing,
re-installed the WirelessDriver software.

Make sure to read the FAQ about proper removal of the existing
wirelessdriver software, It sounds like having an existing version while
performing a re-install rarely ends in success.

But I can say that after two weeks of trying to figure out why my PCMCIA
card (WavLan Silver) was not getting power or showing up in as en1,


After a removal and re-install everything appears to be working properly!!

> I have a Wallstreet running Jaguar.  I'm trying to use a Cabletron RoamAb=
out
> 802.11 DS card.  The instructions say to select en1 or en2 as the network
> interface to access the network.  However, my only options are Modem/Prin=
ter
> Port, Infrared, Internal Modem, and Built-in Ethernet.  How do I get the =
en1
> or en2 options to appear?
>=20
>=20
> -------------------------------------------------------
> This SF.NET email is sponsored by:
> SourceForge Enterprise Edition + IBM + LinuxWorld =3D Something 2 See!
> http://www.vasoftware.com
> _______________________________________________
> Wirelessdriver-support mailing list
> Wir...@li...
> https://lists.sourceforge.net/lists/listinfo/wirelessdriver-support
>=20


www.interactivehank.com is now open for business.

It ain=B9t all there yet, but then again it may never be.