[Wirelessdriver-support] No EN1 or EN2

[Ken S. <ksi...@op...>]

Worked out the problem. The Wireless Driver extension (kext) needs ot 
be manually put in to System/Library/Extensions/ and then a restart. 
The installer does not put in the correct place automatically.

This would be good to put into the FAQ.




Hi I too am having the no new network problem. My Cabletron Enterasys 
Roamabout card is seen by the PC card slot but no new entries in the 
Network preferences pane. 10.2.2, TiBook 400 384MB.

Any suggestions greatly appreciated

### system info

ProductName:    Mac OS X
ProductVersion: 10.2.2
BuildVersion:   6F21
Darwin Kens-TiBook.local. 6.2 Darwin Kernel Version 6.2: Tue Nov  5 
22:00:03 PST 2002; root:xnu/xnu-344.12.2.obj~1/RELEASE_PPC  Power 
Macintosh powerpc
ppc7400

### wireless driver files installed

drwxr-xr-x    3 root  wheel   102 Nov  6 17:04 IOPCCardFamily.kext
2002-11-29 14:28:52.506 defaults[714]
The domain/default pair of (loginwindow, 
AutoLaunchedApplicationDictionary) does not exist

### wirelesscard info

     | |             "VersionOneInfo" = ("Cabletron","RoamAbout 802.11 
DS","Vers$
     | |       +-o pccard156,2@0,0  <class IOPCCard16Device>
     | |             "IOName" = "pccard156,2"

### network info

lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
         inet6 ::1 prefixlen 128
         inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1
         inet 127.0.0.1 netmask 0xff000000
gif0: flags=8010<POINTOPOINT,MULTICAST> mtu 1280
stf0: flags=0<> mtu 1280
en1: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
         inet6 fe80::230:65ff:fe11:d6f1%en1 prefixlen 64 scopeid 0x4
         inet 192.168.0.3 netmask 0xffffff00 broadcast 192.168.0.255
         ether 00:30:65:11:d6:f1
         media: autoselect status: active
         supported media: autoselect
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
         inet6 fe80::230:65ff:fecc:4124%en0 prefixlen 64 scopeid 0x5
         ether 00:30:65:cc:41:24
         media: autoselect (none) status: inactive
         supported media: none autoselect 10baseT/UTP <half-duplex> 
10baseT/UTP <half-duplex,hw-loopback> 10baseT/UTP <full-duplex> 
10baseT/UTP <full-duplex,hw-loopback> 100baseTX <half-duplex> 
100baseTX <half-duplex,hw-loopback> 100baseTX <full-duplex> 100baseTX 
<full-duplex,hw-loopback>

### wd command line tool status
-- 
Regards
Ken Simpson