I noticed WinStep is very heavy on memory usage. On my system* it is using 255 Mb of RAM ! Compare it to, say, Nexus Dock wich is using 13 Mb.
Is there a way to prevent that ?
NB : I noticed that after an undifined lapse of time, if not activated again (by entreing the trigering corner of the screen) ( around 20-30 minutes, but it is not constant), the amout of RAM used suddenly drops to an acceptable amount (around 15-30 Mo). If triggered again, the RAM usage immediatly rise again. I suppose this is an intended behaviour, such as a high level/low level standby mode ?
If so, is there a way by parameters or by recompilation) to lower this duration to a few minuts or seconds, or even better, to completly revert to low RAM usage level immediatly after each use ?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I noticed WinStep is very heavy on memory usage. On my system* it is using 255 Mb of RAM ! Compare it to, say, Nexus Dock wich is using 13 Mb.
Is there a way to prevent that ?
NB : I noticed that after an undifined lapse of time, if not activated again (by entreing the trigering corner of the screen) ( around 20-30 minutes, but it is not constant), the amout of RAM used suddenly drops to an acceptable amount (around 15-30 Mo). If triggered again, the RAM usage immediatly rise again. I suppose this is an intended behaviour, such as a high level/low level standby mode ?
If so, is there a way by parameters or by recompilation) to lower this duration to a few minuts or seconds, or even better, to completly revert to low RAM usage level immediatly after each use ?