From: Sebastian O. <ker...@gm...> - 2005-03-10 17:36:43
|
Am Donnerstag, den 10.03.2005, 19:26 +0200 schrieb Thimios Dimopulos: > Sebastian Ortwein wrote: > > >Hey > > > >I get following errors with my Browser in wifiadmin > >in wireless status > > > >Notice: Undefined variable: current in /var/www/wifiadmin/iwstatus.php > >on line 106 > > > >Notice: Undefined variable: current in /var/www/wifiadmin/iwstatus.php > >on line 330 > > > >status > >This device\'s mode is not supported. > > > > > >Notice: Undefined variable: current in /var/www/wifiadmin/iwstatus.php > >on line 345 > > > >___________________________________________ > > > >in wireless settings > > > >Wireless Settings > > > >Notice: Undefined variable: current in /var/www/wifiadmin/iwsettings.php > >on line 200 > > > >Current settings for device > > > >___________________________________________ > > > >I used today CVS sources and i try to get it running under debian with > >apache 1.3 and php4. I dont't know where is my problem I have installed > >php4-cli but I don't know how to check it. > > > > > > > > > > > Please provide more details. Post the output of the following: > > iwconfig --version iwconfig Wireless-Tools version 27 Compatible with Wireless Extension v11 to v17. Kernel Currently compiled with Wireless Extension v16. eth2 Recommend Wireless Extension v16 or later, Currently compiled with Wireless Extension v16. > > iwconfig lo no wireless extensions. eth0 no wireless extensions. eth1 no wireless extensions. eth2 IEEE 802.11b/g Mode:Managed Frequency:2.422GHz Access Point: 00:00:00:00:00:00 Bit Rate:0kb/s Tx-Power=31 dBm Sensitivity=20/200 Retry min limit:8 RTS thr:2347 B Fragment thr:2346 B Encryption key:off Link Quality:33 Signal level:0 Noise level:19 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 ppp0 no wireless extensions. > > ifconfig > eth0 Link encap:Ethernet HWaddr 00:50:FC:39:CD:F6 inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:761544 errors:0 dropped:0 overruns:0 frame:0 TX packets:643074 errors:0 dropped:0 overruns:1 carrier:0 collisions:0 txqueuelen:1000 RX bytes:675720758 (644.4 MiB) TX bytes:95344004 (90.9 MiB) Interrupt:12 eth1 Link encap:Ethernet HWaddr 00:04:75:9D:5D:62 inet addr:192.168.2.1 Bcast:192.168.2.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:1910750 errors:0 dropped:0 overruns:2 frame:0 TX packets:2343936 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:805944616 (768.6 MiB) TX bytes:2692199645 (2.5 GiB) Interrupt:10 Base address:0xb000 eth2 Link encap:Ethernet HWaddr 00:01:36:07:11:8C inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:185 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:39463 (38.5 KiB) Interrupt:12 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:15140 errors:0 dropped:0 overruns:0 frame:0 TX packets:15140 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1581832 (1.5 MiB) TX bytes:1581832 (1.5 MiB) ppp0 Link encap:Point-to-Point Protocol inet addr:85.74.8.70 P-t-P:62.104.190.40 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1454 Metric:1 RX packets:760936 errors:0 dropped:0 overruns:0 frame:0 TX packets:642285 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:3 RX bytes:658830010 (628.3 MiB) TX bytes:81125850 (77.3 MiB) > if you are using the hostap driver, also post the output of > > ls -lhR /proc/net/hostap/ i have no hostap driver > I hope it help. It is the first time I try a wireless connection in Linux. I will use your program for a wireless-linux-router. I use a old debian woody so it can be that same programs are outdated with your webinterface. Thanks for the help -- Sebastian Ortwein <ker...@gm...> |