you are the first to report this. i shall assign wifi to look at
this but question to you is have you setup linksys router
correctly for it to work? you give us very little detail and
what settings you used etc. like saying i have a punchture in
one of my wheels and i drive a 40 ft lorry with 20 odd
wheels:)
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
this problem was on ver 2.02.2.1pre-wfb, H/W ver1.1
I am sure I have set all parameter correctly. I have tried re-
boot, use a differnt account.... , but it doesn't work. No
message showed below.
So I roll back to ver 2.00.8pre-i, it works perfectly.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
This function works now, but it does not show the results in
the "status:" position after you do an update. It would be
nice to say what the results were in the status position.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Logged In: YES
user_id=948364
which firmwire version ?
Logged In: YES
user_id=970605
you are the first to report this. i shall assign wifi to look at
this but question to you is have you setup linksys router
correctly for it to work? you give us very little detail and
what settings you used etc. like saying i have a punchture in
one of my wheels and i drive a 40 ft lorry with 20 odd
wheels:)
Logged In: NO
this problem was on ver 2.02.2.1pre-wfb, H/W ver1.1
I am sure I have set all parameter correctly. I have tried re-
boot, use a differnt account.... , but it doesn't work. No
message showed below.
So I roll back to ver 2.00.8pre-i, it works perfectly.
Logged In: YES
user_id=970605
wifi he said 2.02.2.1pre-wfb
2.00.8 worked ok. so must be something wrong with zoneedit
ddns
Logged In: NO
same problem here
Firmware Version: v2.02.2
Wifi-box.net Release Version: 2.02.2.1.wfb 01/02/2004
Logged In: YES
user_id=565719
This function works now, but it does not show the results in
the "status:" position after you do an update. It would be
nice to say what the results were in the status position.