Hello,
How can I set up WANem 3.0 beta as an Ethernet bridge?
The ReadMe mentioned "WANem Prompt --> bridge", so I used that command to create a bridge with both of my NIC cards.
But, how I assign a bandwidth to that bridge?
The WANem interface has a "select bridge" button, but it does not do anything obvius nor have I seen this documented anywhere.
What should I be doing?
Thank you nott
Bump...
Does anybody know the correct way to add latency/bandwidth to a bridge?
It seems that you just have to assign the parameters separately to both interfaces of the bridge.
By the way, I needed to ifup the bridge before I could use it.
Another problem is that you cannot select the bridge in the advanced configuration...
Log in to post a comment.
Hello,
How can I set up WANem 3.0 beta as an Ethernet bridge?
The ReadMe mentioned "WANem Prompt --> bridge", so I used that command to create a bridge with both of my NIC cards.
But, how I assign a bandwidth to that bridge?
The WANem interface has a "select bridge" button, but it does not do anything obvius nor have I seen this documented anywhere.
What should I be doing?
Thank you
nott
Bump...
Does anybody know the correct way to add latency/bandwidth to a bridge?
It seems that you just have to assign the parameters separately to both interfaces of the bridge.
By the way, I needed to ifup the bridge before I could use it.
Another problem is that you cannot select the bridge in the advanced configuration...