I'm trying to configure a linux embedded client and Windows host to route through the Wanem etho interface. The Windows host routing is no problem. The embedded client connects to the network via wireless access point. There is a way to configure a static IP, mask, and default gateway on the embedded client, but there is no way to configure a route. Has anyone done this type of configuration before? What are my options?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
1. Create a new subnet for emmbedded client and WANem and assign their IP adresses accordingly.
2. Set the default gateway in WANem same as subnet default gateway
3. Set default gateway to WANem IP in embedded client.
4. On WANem console add a nat on etho (use "nat add" command)
(No need to add route on Windows host.)
All the best.
Regards,
M.K.Nambiar
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm trying to configure a linux embedded client and Windows host to route through the Wanem etho interface. The Windows host routing is no problem. The embedded client connects to the network via wireless access point. There is a way to configure a static IP, mask, and default gateway on the embedded client, but there is no way to configure a route. Has anyone done this type of configuration before? What are my options?
1. Create a new subnet for emmbedded client and WANem and assign their IP adresses accordingly.
2. Set the default gateway in WANem same as subnet default gateway
3. Set default gateway to WANem IP in embedded client.
4. On WANem console add a nat on etho (use "nat add" command)
(No need to add route on Windows host.)
All the best.
Regards,
M.K.Nambiar