Thanks for great product!! I have some basic questions.
After working with Wanem is it possible to save all configuration on the harddrive insted if ram? I just buy new computer with four nic cards for the simulation. My next question is about how to configure three diffrent network. Exempel first network is eth0:192.168.10.0/24 eth1:192.168.10.0/24 eth2:192.168.30.0/24. There should be full access between these networks. How to that?
please write me all the needed information with defaultgateways, routes.. etc.
During WANem startup you will have to setup IP addresses on eth0, eth1 and eth2 on with IP addresses belonging to the subnet they are connected to.
By default there will be full access.
Since eth0 and eth1 are in the same subnet you may need to use the "assign" command in the WANem console to get correct emulation. Please refer to the manual for more details.
Are you facing any specific problem.
Log in to post a comment.
Sign up for the SourceForge newsletter:
You seem to have CSS turned off.
Please don't fill out this field.