Performing a Full Scan, does not refresh the Results Tab.
So for example after performing a scan, and then fixing some code issues, I then clicked, "Full Scan" again and expected the results to refresh with the new results. however the presious results are still displayed.
It would be good if you could fix this as currently the only workaround I have found is to Clear all results, Re-Add the target files and then Scan again, but this make fixing and rechecking very slow going.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Performing a Full Scan, does not refresh the Results Tab.
So for example after performing a scan, and then fixing some code issues, I then clicked, "Full Scan" again and expected the results to refresh with the new results. however the presious results are still displayed.
It would be good if you could fix this as currently the only workaround I have found is to Clear all results, Re-Add the target files and then Scan again, but this make fixing and rechecking very slow going.