Using the explicit mode in 2D, i attempted 3 times to created a 'curve - spline - chord length, ferguson, and variable stiffness' using abs and about 20 data points on all 3 attempts. The curve generated properly, but when I tried to make a mirror of it, I am unable to select the entity.
When I create an 'arc' of some sort, I can make a mirror of that entity. Does anyone else have this problem?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Varkon currently does not support interactive mirroring of curves.
This is a stupid limitation since it is supported in MBS.
I will take alook into this as soon as possible.
Johan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Using the explicit mode in 2D, i attempted 3 times to created a 'curve - spline - chord length, ferguson, and variable stiffness' using abs and about 20 data points on all 3 attempts. The curve generated properly, but when I tried to make a mirror of it, I am unable to select the entity.
When I create an 'arc' of some sort, I can make a mirror of that entity. Does anyone else have this problem?
Varkon currently does not support interactive mirroring of curves.
This is a stupid limitation since it is supported in MBS.
I will take alook into this as soon as possible.
Johan