Plus I noticed that when I connect the programmer with a target
PIC24FJ256DA206 already connected the software tells me:
29.06.2012 23:46:59: Error setting configuration of the USB device: Pipe
error
29.06.2012 23:46:59: Bootloader or programmer not found
The same thing happens when I first connect the programmer without the
target PIC (programmer is detected ok) and then connect the target a
e.g. select "autodetect"...
Am 29.06.2012 23:24, schrieb Kim Rosenbohm:
> Hi All.
>
> I was naive when ordering the USBPICPROG hardware and though it
> supported 24FJ256 -Types so it would support the DA206 version too, but
> I only see -GA1xx and -GB1xx types in the software.
> What can I do to flash that chip? It would suffice to flash the
> bootloader...
>
> Best Regards,
>
> Kim
>
|
