usbpicprog-technical

[Usbpicprog-technical] dsPIC30F2020 question

[Ken S. <ksa...@tr...>]

Hi All

Just a question about the supported devices. I'm looking to work with 
the SMPS capable dsPIC30F devices (eg dsPIC30F2020), which appear to 
differ from other dsPIC30F versions, in particular being low voltage 
programmable and also appear to use somewhat different low level 
programming protocols. Could someone please verify that the usbpicprog 
firmware will handle these differences, and not apply high voltage 
programming?

cheers and thanks, Ken

-- 
Linux Error Message:
Font: "Helvetica" does not appear to be either a font file or registered with ImageMagick.
A similarly-named font was not found. Sorry! The font "Helvetica" will be used instead.

Re: [Usbpicprog-technical] dsPIC30F2020 question

[Frans S. <fra...@gm...>]

Hi Ken,

The devices you are mentioning have now just been implemented like any
other dsPIC30F device, and this should indeed have a different protocol,
entering the programming mode. The protocol is more or less like the
18FXXJXXXX devices which have recently been implemented.
I have added the 3 devices as not working on the supported devices page.
I will soon try implementing the differences in those devices.
Thank you for letting me know.

Kind regards,

Frans Schreuder

On 11/02/2010 12:28 AM, Ken Sarkies wrote:
> Hi All
>
> Just a question about the supported devices. I'm looking to work with 
> the SMPS capable dsPIC30F devices (eg dsPIC30F2020), which appear to 
> differ from other dsPIC30F versions, in particular being low voltage 
> programmable and also appear to use somewhat different low level 
> programming protocols. Could someone please verify that the usbpicprog 
> firmware will handle these differences, and not apply high voltage 
> programming?
>
> cheers and thanks, Ken
>