Hi,
I just got my picprog and I'm implementing my own software for writing flash and EEPROM for two PIC MCU:s, 18F8722 and 18F87K90.
I understand that (at least rudimentary) support for both has been implemented, but I could not find the 87K90 in the PicFamily enumerations on your PC software source code, neither could I find it on the device source codes.
I'm not really familiar with the electrical characteristics of the programming interface on PIC MCU:s, however, I understand that different PIC:s might and quite often will require different programming algorithms.
Is it possible to set a similar PIC family to picprog, to program 18F87K90 MCU:s ?
Thank you in advance.
PS. Is the documenation on http://usbpicprog.org/?page_id=15 still valid ? I noticed by browsing through the PC software sources, that at least the Upp_Packet/Package has increased in size (38->56 bytes).
Regards,
Ville
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I just got my picprog and I'm implementing my own software for writing flash and EEPROM for two PIC MCU:s, 18F8722 and 18F87K90.
I understand that (at least rudimentary) support for both has been implemented, but I could not find the 87K90 in the PicFamily enumerations on your PC software source code, neither could I find it on the device source codes.
I'm not really familiar with the electrical characteristics of the programming interface on PIC MCU:s, however, I understand that different PIC:s might and quite often will require different programming algorithms.
Is it possible to set a similar PIC family to picprog, to program 18F87K90 MCU:s ?
Thank you in advance.
PS. Is the documenation on http://usbpicprog.org/?page_id=15 still valid ? I noticed by browsing through the PC software sources, that at least the Upp_Packet/Package has increased in size (38->56 bytes).
Regards,
Ville