I had construct the PCB using donut board with PIC18F2550, had tried with firmware 0.6 or bootloader 1.0 (both hex)
I program it using ICD-U64 from CCS, when the USB is connected to the device board, PID and HID detected, but the driver not able to load automatically. I had successful load it with the program Zadig for win8, with the selection of libusb-win32(the only one work)
I fire up the usbpicprog .exe with admin or non-admin, the programmer not detect.
Anything I left out here?
*note
I only construct the USB part to make the firmware and software work, this test is only verified the compatible for my project, after this, I would like to get around 10 units fully mounted from your store. Please Kindly respond my question. Thanks.
I need it to work on command prompt so i can integrate this device with my software.
I wrongly place the 100nF capacitor for Vusb on pin-28,
after relocate the capacitor, I delete all driver, and remount the device again, new usb device detected, and with hardware description of "usbpicprog.org" with PID,HID, after install with the .inf file in driver folder the programmer detected by the program.
Hello,
I had construct the PCB using donut board with PIC18F2550, had tried with firmware 0.6 or bootloader 1.0 (both hex)
I program it using ICD-U64 from CCS, when the USB is connected to the device board, PID and HID detected, but the driver not able to load automatically. I had successful load it with the program Zadig for win8, with the selection of libusb-win32(the only one work)
I fire up the usbpicprog .exe with admin or non-admin, the programmer not detect.
Anything I left out here?
*note
I only construct the USB part to make the firmware and software work, this test is only verified the compatible for my project, after this, I would like to get around 10 units fully mounted from your store. Please Kindly respond my question. Thanks.
I need it to work on command prompt so i can integrate this device with my software.
Last edit: iRviNe48 2014-04-29
Problem solved,
I wrongly place the 100nF capacitor for Vusb on pin-28,
after relocate the capacitor, I delete all driver, and remount the device again, new usb device detected, and with hardware description of "usbpicprog.org" with PID,HID, after install with the .inf file in driver folder the programmer detected by the program.
*thread closed.
Last edit: iRviNe48 2014-04-29
Good to hear that it was fixed.
Frans