Hello Everyone, How can I measure/scan only one point with Hokuyo UTM-30LX-EW ?
Best Regards, Yakov.
You seem to have CSS turned off. Please don't fill out this field.
Anonymous
Hi, Yakov
I noticed that you also sent an email to us. We will reply by email.
Thank you. Best regards, Hongwei Liu Sales Department Hokuyo Automatic Co., Ltd. http://www.hokuyo-aut.jp/ TEL: +81-6-6947-6333
Hi,
sorry for getting back to this old subject but I'm also interested into getting one single pair of coordinate instead of multiple data points.
Is it possible to elaborate more on this subject ?
The measurement command can set start and End steps.
The example of GD command is "GD0540054000".
You can get the data of one step.
For details of other commands, refer to the communication specification from the product page of the following link. https://www.hokuyo-aut.jp/search/index.php?cate01=1&cate02=1&cate03=
Best Regards.
View and moderate all "General Discussion" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
Hello Everyone,
How can I measure/scan only one point with Hokuyo UTM-30LX-EW ?
Best Regards,
Yakov.
Hi, Yakov
I noticed that you also sent an email to us.
We will reply by email.
Thank you.
Best regards,
Hongwei Liu
Sales Department
Hokuyo Automatic Co., Ltd.
http://www.hokuyo-aut.jp/
TEL: +81-6-6947-6333
View and moderate all "General Discussion" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
Hi,
sorry for getting back to this old subject but I'm also interested into getting one single pair of coordinate instead of multiple data points.
Is it possible to elaborate more on this subject ?
Hi,
The measurement command can set start and End steps.
The example of GD command is "GD0540054000".
You can get the data of one step.
For details of other commands, refer to the communication specification from the product page of the following link.
https://www.hokuyo-aut.jp/search/index.php?cate01=1&cate02=1&cate03=
Best Regards.