I'm trying to fully optimise a drive and every time optimisation completes with status: 3 passes needed. Is this a bug in 6.0.4? I've now upgraded to 6.1.0 and am running full optimisation for the first time so once I've run it a few times I'll see if the result is the same. (I'm pretty sure the version I was using was 6.0.4 but now that I've installed the update I can't check. Also I checked for the Install file but it isn't there..)
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi
I'm trying to fully optimise a drive and every time optimisation completes with status: 3 passes needed. Is this a bug in 6.0.4? I've now upgraded to 6.1.0 and am running full optimisation for the first time so once I've run it a few times I'll see if the result is the same. (I'm pretty sure the version I was using was 6.0.4 but now that I've installed the update I can't check. Also I checked for the Install file but it isn't there..)
The wording is a bit misleading, but that is corrected in v 6.1.0
It is meant as "3 passes executed".
Stefan
So optimising has been completed?
Sorry. Stupid question, I understand