[Towhee-bugs] Questions regarding running parallel towhee jobs on a remote system

[Amanda C. <aa...@en...>]

Dear TOWHEE management team,

Good afternoon, this is Amanda, a user of Towhee software (version 8.2.3).
I encounter some issues while running the parallel jobs on a remote system
and hope to have some instructions from you.

Currently, I compiled towhee (version 8.2.3) on a remote system via "
./configure
--enable-mpi".  The software was able to be compiled without error codes.
However, a job was ended up with the following error message while running
it:
"Warning: MPI not supported, parstyle JOBFARM disabled.
Doing nothing."

I'm wondering if you have any suggestions on resolving this issue.  Any
suggestions will be much appreciated.  Thank you for your time and
assistance.
p.s. The attached files were run with n=16.   (srun -n 16
~/towhee-8.2.3/Source/towhee -p jobfarm towhee_input )

Sincerely,
Amanda

-- 
Advanced Thermodynamics, Light-Matter-Interactions and Simulations Lab
Department of NanoEngineering
Email: aa...@en...
University of California - San Diego