Command Line Parameter

Serial Bootloader for Microchip, Atmel, NXP, TI, 8051 microcontrolers

Status: Beta

Brought to you by: edorul, evanvennn

Command Line Parameter

Forum: Requests

Creator: Anobium

Created: 2015-01-27

Updated: 2016-03-11

Anobium - 2015-01-27

What is the command line parameter to exit after programming?

I am using: Tiny_Avr-Pic_Bootloader+ (v0.9.0)\Tiny_Avr-Pic_Bootloader+.exe" %1 COM12 38400 EXIT

With EXIT as the last parameter this does not exit.

Most grateful for a response.

:-)

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

edorul - 2015-02-01

Hello Anobium,

There is no command line parameter to exit TinyBootloader after programming.
But, this is a good idea. So I'll add an "exit" option in case of a successfull write.

Thanks for your request!

Best regards,
Edorul

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Anobium - 2015-11-22

Any news on this? would be great for Great Cow Basic support.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anobium - 2015-11-24
  
  I found the new version has this capability!
  
  Thank you.
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Hanspeter - 2016-03-11

Last edit: Hanspeter 2016-03-11

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.