Hi,
my switchmap 14 don't show ip and the dns name from devices at the switchport (only mac address is shown)
This problem i have on two cisco switch models 3560 and 3850.
Which comand script and command are used to get the ip and dns name? If i know this i can test the switch directly, because it passible that something is not right configured, because some switches have the informationes of ip and dns name.
thanks,
Oliver
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
my switchmap 14 don't show ip and the dns name from devices at the switchport (only mac address is shown)
This problem i have on two cisco switch models 3560 and 3850.
Which comand script and command are used to get the ip and dns name? If i know this i can test the switch directly, because it passible that something is not right configured, because some switches have the informationes of ip and dns name.
thanks,
Oliver
Hi Oliver,
Perhaps you have the same issue as we do. Are you also missing:
state
speed
Thanks, Simon