From: Sandhya K G <sandhyakg@in...> - 2012-08-28 03:50:15
I am working with SWAN 40.85.
I am setting up SWAN using unstructured meshes. In this connection I prepared an unstructured mesh using SMS. I could run SWAN with this mesh file (fort.14) in serial and shared memory (OMP) modes, using the swan.exe from the serial mode installation. Now I would like to install Unstructured SWAN in MPI (distributed memory) mode. I understand that this installation is somewhat different from the normal parallel SWAN installation. The punswan requires some files from adcirc for installation and running. Where do I get these adcirc files from?
Though I have gone through the relevant chapter in SWAN manual, the installation process of parallel unstructured SWAN is not clear to me.
Could anyone please tell me the exact installation/run procedure of punswan and point to the source of required files?
Thank you very much in advance.
Sandhya K G
INDIAN NATIONAL CENTRE FOR OCEAN INFORMATION SERVICES
(Ministry of Earth Sciences, Govt. of India)
"Ocean Valley", Pragathi Nagar (B.O), Nizampet (S.O), HYDERABAD-500 090.
Ph : 040 23886036