[Svxlink-devel] no_repeat still doesn't work propperly
Brought to you by:
sm0svx
From: Nils P. <mai...@ni...> - 2008-08-15 09:15:28
|
Hello Tobias, hello @ all, at our node (Debian Lenny, Svx 080730, RepeaterLogic) the following error occurs: If I activate the no_repeat keyword and the "line output" in the ALSA mixer all works fine except when a signal is received on the RX while the repeater is still playing any raw file. In that case the internal audio of Svx mutes and never comes back: no roger beep, no EchoLink announcements, just nothing. Additionally, SvxLink hangs and doesn't shut down the repeater even when the hold timer has exceeded for minutes. The output to stdout (in non-daemon mode) and the log file goes on and you can see what should happen (e.g. connects from the EchoLink site or turning on and off the RX) but all you can hear is the audio received by RX1. If you wait until SvxLink has played all his audio (e.g. his ID) and then start sending all works fine. In older versions this error was never seen although we used SvxLink with no_repeat for about 1 1/2 years. -- Tnx es 73, Nils DB0OSN-R |