Re: [sumo-user] How to disable the car following model?

[Jakob E. <nam...@go...>]

Use the 'speed mode' command (
http://sumo.dlr.de/wiki/TraCI/Change_Vehicle_State)
regards,
Jakob

2015-10-07 11:17 GMT+02:00 Bing Liu <lbe...@gm...>:

> Hello everyone,
>
> I'm using SUMO 0.22 and Traci in my research. The code is written in Matlab
> to control the vehicles in SUMO via Traci.
>
> I have problem like this :
>
> I use the command *traci.vehicle.setSpeed(vehicle_id,velocity)* to set the
> speed of a vehicle. If the vehicle is far enough from the preceding
> vehicle, there is no problem; but when it is close, the vehicle tend to
> slow down.
>
> I think it is the car following model which takes over.
>
> I want to know it is possible to disable the car following model in some
> simulation steps and enable it again when necessary?
>
> Thanks in advance.
>
> LIU Bing
> PhD Student
> CNRS - CRIStAL - UMR 9189
> Ecole Centrale de Lille
> Cité Scientifique -B. P. 48 F 59651 Villeneuve D'Ascq cedex, France
>
> ------------------------------------------------------------------------------
> Full-scale, agent-less Infrastructure Monitoring from a single dashboard
> Integrate with 40+ ManageEngine ITSM Solutions for complete visibility
> Physical-Virtual-Cloud Infrastructure monitoring from one console
> Real user monitoring with APM Insights and performance trend reports
> Learn More
> http://pubads.g.doubleclick.net/gampad/clk?id=247754911&iu=/4140
> _______________________________________________
> sumo-user mailing list
> sum...@li...
> https://lists.sourceforge.net/lists/listinfo/sumo-user
>