On 2/25/06, Robert Wachinger <email@example.com> wrote:
On Sat, Feb 25, 2006 at 01:05:32PM +0100, Ewald Geschwinde wrote:
> I have installed a development version on debian
> I do apt-get install openssi
> All works as expected.
You did follow the description in the installation manual
Esp.assigning a clustenode number for your initnode and choosing
an interface as cluster-interconnect?
yes I have one with 192.168.0.20
and the ip from the docs 172....
I have done nothing other than in the docs - it was running
nuder vmware but there I had problems with packet loss but this
was a system problem
What is the content of your /etc/clustertab
I have the problems in the first node
Was the openSSI-initrd generated correctly?
where do I find this file ?
> But on reboot the system hangs with the following message:
> WARNING: Could not find a NIC with a static node configuration.
> Dynamically allocating an IP address and node number.
> WARNING: Could not find the NIC used to add this node to the cluster.
> Unable to continue. Halting.
> The I rebooted with my standard sarge
> And the file /etc/network/interfaces WAS EMPTY.
You really do not need more than:
iface lo inet loopback
in this file, because the Cluster-interconnect will be established
during boot. /etc/network/interfaces is only needed for additional
the network adresses are ok in the /cluster/node1/etc/network/interfaces
I think this was the dir
> I have edited the file before the reboot and it looked good and I had
> internet access from the LAN nic and I could ping the cluster NIC.
BTW: /etc/network is a "local link"