Re: [SSHGuard-users] Remove ip from blocked table

[James H. <jam...@gm...>]

Just delete the line from the text file. I believe historically the file
had been binary but was converted to text. You can also whitelist addresses
you know are good. I whitelist the rfc 1918 addresses just to prevent any
parsing error causing too much trouble.

On Fri, Jun 10, 2016 at 12:57 AM, Jos Chrispijn <ssh...@cl...>
wrote:

> In een bericht van 9-6-2016 23:06:
>
> >> Can you tell me what the best way is of removing a blocked IP from
> SSHGuard?
> >
> > Someone please correct me if I am mistaken. But typically a reboot of
> the system / SSHGuard will take care of this?
>
> Don't think so - blocked IP's are normally registered in a *.db (which
> isn't a database but a textfile (I think). My question actually referred
> to this file - can I just edit the file and remove some of the IP's or
> should I do that from the sshguard command line?
>
> /Jos
>
>
>
>
> ------------------------------------------------------------------------------
> What NetFlow Analyzer can do for you? Monitors network bandwidth and
> traffic
> patterns at an interface-level. Reveals which users, apps, and protocols
> are
> consuming the most bandwidth. Provides multi-vendor support for NetFlow,
> J-Flow, sFlow and other flows. Make informed decisions using capacity
> planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
> _______________________________________________
> sshguard-users mailing list
> ssh...@li...
> https://lists.sourceforge.net/lists/listinfo/sshguard-users
>



-- 
James Harris
Software Engineer
jam...@gm...