the way i did it was to install the library first, and then math-pari
after using the following:
wget ftp://megrez.math.u-bordeaux.fr/pub/pari/unix/pari-2.1.6.tgz && tar -xzvf pari-2.1.6.tgz && cd pari-2.1.6 && sh ./Configure && make install && wget http://search.cpan.org/CPAN/authors/id/I/IL/ILYAZ/modules/Math-Pari-2.010603.tar.gz && tar -xzvf Math-Pari-2.010603.tar.gz && cd Math-Pari-2.010603 && perl Makefile.PL && make && make test && make install && cd .. && cd .. && rm -rf pari-2.1.6 && rm -f pari-2.1.6.tgz
i hope this helps,
Aloha,
rv,
> I want to use Net::SSH::Perl-module, but aparently you need
> to install Math::Pari and the corresponding Pari library.
> Since I have no root access on my computer (only sysadmins have, grrrr),
> I have to indicate that the installation directory is not /usr/local/
> but a /link/to/my/dir/. Is there a way to do this? (the option
> --prefix=... doesn't exist here??).
> And how do I indicate where my Pari Library is installed? Do I have to
> manually change it in the MakeFile.PL?
> Are there people out there that suffered the same problem?
>
>
> Thanx in advanace,
>
> Regards,
> Pieter
>
>
>
> Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
>
>
>
> -------------------------------------------------------
> SF.Net email is Sponsored by the Better Software Conference & EXPO
> September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
> Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
> Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
> _______________________________________________
> Ssh-sftp-perl-users mailing list
> Ssh...@li...
> https://lists.sourceforge.net/lists/listinfo/ssh-sftp-perl-users
>
--BEGIN GC BLOCK V3.12--
GO d? s-:-- !a C++ L++ P++ UL++ E- W-- N+ o K?
w--- M V-- PS+++ Y+ PGP R* !tv b+ G e+++ h y*
------END GC BLOCK------
|