CLP-300 cannot print in 1200 dpi
Brought to you by:
ap2c
Hi,
I send this patch in a personal mail a month and a half ago, but it hasn't been addressed, so I am reposting it in case it's useful for someone.
CLP-300 seems to be rather picky about the input data width, especially in the 1200 dpi mode - it seems that both too narrow or too wide is bad. Stripping the horizontal HWMargin also from the right side does the trick.
Without the patch, 1200 dpi prints are a complete garbage.
Thank you very much for this patch. I applied it and it is available in the SVN head.
Regards,
Aurélien
There are still garbage present in the left margin..
I will try to fix it when i'll have some time.
Does it works with CLP-300 ?
I only tested monochrome, but it looks ok.
This Tracker item was closed automatically by the system. It was
previously set to a Pending status, and the original submitter
did not respond within 14 days (the time period specified by
the administrator of this Tracker).