How do I verify that the exclusion rule is working properly?
I have a 4 drive pooled setup (1 x 2TB, 2 x 3TB, 1x4TB) with a 4TB parity drive. My drive with the most information is 1.38TB, but my SnapRaid.Parity file is only 1.27TB. I like to see why it is so much smaller than my data?
Most my files are movie media, so most files are quite large >1GB, does this help with SnapRaid's efficiency, is this why my parity data is smaller?
Nevertheless is there a way to see what's in the parity file (i.e. protected files)?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
I created an exclusion rules as follows:
exclude \$RECYCLE.BIN\
exclude \System Volume Information\
exclude *.bak
exclude Thumbs.db
exclude .ds_store
exclude FOLDER.DUPLICATE.$DRIVEBENDER\
How do I verify that the exclusion rule is working properly?
I have a 4 drive pooled setup (1 x 2TB, 2 x 3TB, 1x4TB) with a 4TB parity drive. My drive with the most information is 1.38TB, but my SnapRaid.Parity file is only 1.27TB. I like to see why it is so much smaller than my data?
Most my files are movie media, so most files are quite large >1GB, does this help with SnapRaid's efficiency, is this why my parity data is smaller?
Nevertheless is there a way to see what's in the parity file (i.e. protected files)?
Nevermind, saw in the manual there is a list command.
Interestingly the command line help doesn't list the list command?
Opps... It's something that will be fixed in the next version.
Ciao,
Andrea