In fact I fix this issue!! :)

I did this : sudo apt-get install libsnmp-dev and I add the third line in etc/snmp/snmpd.conf. I am not sure the two elements are linked, but now it works.

ACCESS CONTROL
#

                                                 #  system + hrSystem groups only
view   systemonly  included   .1.3.6.1.2.1.1
view   systemonly  included   .1.3.6.1.2.1.25.1
view   systemonly  included .1                    <------------

I am not sure to understand what it does, so if you know let me know :).
-----------
I have still an error with the pnp4nagios for the graph, the graphs don't print (I have installed pnp4nagios and I have the module PNP_UI in shinken-specific.cfg)

brokerd.log : 
2012-11-14 17:53:53,557 [1352944433] Warning : Printing stored debug messages prior to our daemonization
2012-11-14 17:56:43,180 [1352944603] Warning : [broker-1] Connection problem to the scheduler scheduler-1: connection lost
2012-11-14 17:56:45,339 [1352944605] Warning : [broker-1] Connection problem to the poller poller-1: connection lost
2012-11-14 17:56:46,351 [1352944606] Warning : [broker-1] Connection problem to the reactionner reactionner-1: connection lost
2012-11-14 17:56:49,255 [1352944609] Warning : Printing stored debug messages prior to our daemonization
2012-11-14 18:03:21,085 [1352945001] Warning : [broker-1] Connection problem to the scheduler scheduler-1: connection lost
2012-11-14 18:03:22,276 [1352945002] Warning : [broker-1] Connection problem to the poller poller-1: connection lost
2012-11-14 18:03:23,371 [1352945003] Warning : [broker-1] Connection problem to the reactionner reactionner-1: connection lost: [Errno 104] Connection reset by peer
2012-11-14 18:03:26,322 [1352945006] Warning : Printing stored debug messages prior to our daemonization

...

I am asking again for help, sorry.

Regards,

Germain.






2012/11/12 Germain tanguy <tanguy.gum@gmail.com>
Hi everybody,

I am a new user of shinken, I install the v1.2 following the tutorial installing shinken in 10 minutes. Then I followed the tutorial : monitoring linux devices (http://www.shinken-monitoring.org/wiki/packs/linux) and in this tutorial it says that the disk spaces, CPU usage, load average..are checked each 5 minutes but I don't understand where can I find the result of this.

Can the result be print on the webui? because right now I don't have the cpu usage or network interface activities.

My goal is just to understand how Shinken works and if with this I can have a kind of graph with CPU usage or something like this..

Sorry it's must be a dumb question, but I am kind of lost now.

Thank in advanced for you help,

Germain.