#225 SACD input issue when used to convert audio files

[Anonymous]

Hi,
I noticed an issue when I convert an sacd iso file to wav 24bit 48kHz. When I open the wav file obtained it is like there's a brickwall lpf applied. I tried with wav obtained from iso, I attached a jpg to illustrate.

[Maxim V.Anisiutkin]

The latest versions of foo_input_sacd plugin use default foobar resampler for 44100x -> 48000x conversion. Not sure, but that might be the reason.

[Anonymous]

Thanks for your answer, is there any way to go around it and use another resampler ?
If not, I'll configure sacd_input on 88.2kHz and create a converter profile with a resampler as dsp and set the sampling rate I want. Thanks again !

[Maxim V.Anisiutkin]

The other way is to setup any resampler in Preferences->Playback->DSP Manager panel.
If you use Multistage DSD2PCM converter try to use DSD2PCM output samplerate as 1/8 of the DSD source sanplerate. For Direct DSD2PCM it's 1/64 or 1/32.

[Anonymous]

Thanks again for your answer & apologies for the delay of mine (very busy week ...) So I tried your way, it works too. I did not have time to compare wav files obtain with each method but I'll do it this week-end. Thanks again.