[RTnet-developers] rtnet wireless configuration
Brought to you by:
bet-frogger,
kiszka
|
From: julian e. <ech...@ho...> - 2010-04-19 11:01:12
|
hello, i need to make the communication wireless between a master and slave with the experimental hardware rt2500 . i do the configuration of the ralink rt2500 card with this steps: 1. I remove the non-realtime network card's device drivers and modules (rmmod 8139too, rt2500). 2. I load the RTAI modules (rtai_hal.ko, rtai_lxrt.ko, rtai_sem.ko, rtai_rtdm.ko). 3. I load the RTNET modules (rtnet.ko, rtipv4.ko, rtpacket.ko). 4. I load the rt2500 card drivers realtime (rt_rt2x00core.ko, rt_rt2500pci.ko, rt_loopback.ko). 5. I configure the rtwlan0 interfaces with rtifconfig and rtiwconfig. I can do "./rtping <IP_ADDR_LOCAL>" to ping the local loopback successfully, when i call "lsmod" , i find the realtime driver of the network card in the loaded module list. But when i want check the communication between the nodes an i run "./rtping <IP_ADDR_SLAVE>", the computer crashes and i must restart the computer also when i want to make the configuration of the routing table with "./rtroute solicit <IP_ADDR_SLAVE> dev rtwlan0" the computer crashes. I do not know what is the problem or i am wrong because with this steps the communication in the wired network with RTNET working properly. Thanks for the help!! Julian Felipe Echeverry Studente Laurea Specialistica Ingegneria Meccatronica Politecnico Di torino Torino, Italia _________________________________________________________________ Hotmail: posta elettronica attendibile grazie alla protezione avanzata Microsoft dalla posta indesiderata. https://signup.live.com/signup.aspx?id=60969 |