I accidently put the 1.26 firmware on a regular ryosmk and now the key board will not work at all. I can read the information with roccatryosmkcontrol but cannot get a gui to either update to the other firmware or reset the factory defaults. trying to update from a terminal just gives a blinking curser. Also as a side note any keyboard i plug into it will change the lights on the ryos if i use cap or num lock.
lshw shows that the keyboard is connected and has the ryosmk pro label. I was wondering if there was anyway to force a reset or force a reflash or if the board is bricked at this point
Thank you for any info you can give in advance
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If you can't update the firmware with roccatryosmkcontrol then the last resort is to open up the keyboard, and flash the right firmware via a JTAG emulator.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
View and moderate all "Help" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
I accidently put the 1.26 firmware on a regular ryosmk and now the key board will not work at all. I can read the information with roccatryosmkcontrol but cannot get a gui to either update to the other firmware or reset the factory defaults. trying to update from a terminal just gives a blinking curser. Also as a side note any keyboard i plug into it will change the lights on the ryos if i use cap or num lock.
lshw shows that the keyboard is connected and has the ryosmk pro label. I was wondering if there was anyway to force a reset or force a reflash or if the board is bricked at this point
Thank you for any info you can give in advance
If you can't update the firmware with roccatryosmkcontrol then the last resort is to open up the keyboard, and flash the right firmware via a JTAG emulator.
View and moderate all "Help" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
Ok thank you very much. I will look into that