commands

Kommandos

Direct Control

Commands to control the RATCOS manual mode functions.

Command	Description	Options
START	Activates the heater control.	program (optional)
STOP	Deactivates the heater control.	no options
SET	Controls heater parameters.	temperature, time (rampmode), power, heater
P1	Power channel 1 - follows "SET" command	0-100
P2	Power channel 2 - follows "SET" command	0-100
T1	Temperature 1 -follows "SET" command	+/- 512
T2	Temperature 2 -follows "SET" command	+/- 512
PWM	PWM Duty Cycle -follows "SET" command	0-255
LED	Program LEDs -follows "SET" command	0,1,2,3,4
MAN	Maintanance and Service section
FPC	Fast Power Control Mode	<startbyte><p1><p2><pwm><led><stopbyte></stopbyte></led></pwm></p2></p1></startbyte>

Example: SET:P1=100\r\n or SET:PWM=200\r\n
Example: SET:T1=320\r\n

\r\n means Carriage return Linefeed

The FPC mode can be entered by typing FPC\r\n
This mode requieres a baud rate greater than 19200 bd.
8 Bytes are send every 10ms. 1 Startbyte, two Bytes Temperature T1, two Bytes Temperature T2, 1 Byte PWM, 1 Byte LED, 1 Stop byte.
The Startbyte has the value 00,
The Stopbyte has the value 0XFF,
The Temperaturebytes are signed integer,
The PWM-Byte is CHAR, 0-255,
The LED-Byte is CHAR, 0,1,2,3 or 4
After that, a pause must follow with at least 6ms.
10 frames per second are send.

Program Control

Commands to control the RATCOS programable mode functions.

Command	Description	Options
PROG	Modify a particular program slot.	program, slot, temperature, time, control