Output to a list of channels

A Python module to control the GPIO on a Raspberry Pi

Brought to you by: croston

#70 Output to a list of channels

Status: Done

Owner: Ben Croston

Labels: None

Priority: Low

Type: Enhancement

Updated: 2014-11-11

Created: 2014-08-04

Creator: Ben Croston

Private: No

In GPIO.output() allow a list of channels, not just one channel.

Discussion

Ben Croston - 2014-10-12

status: Accepted --> Started
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ben Croston - 2014-10-12

Also get setup() to accept list of channels

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ben Croston - 2014-10-12

Added list of channels functionality to setup() too.
Code is in source code library - will be in next release.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ben Croston - 2014-11-11

status: Started --> Done
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ben Croston - 2014-11-11

In release 0.5.8

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.