I noticed that recenly firmwares for the low end configuration have been dropped. This forum contains a few post where people are looking for them. I'm talking about 4M Flash and 32 RAM.
It sounds to me that the LEDE project made an advise but didn't drop anything.
If you refer to the famous WRT54GL who is still sold: https://wiki.openwrt.org/toh/linksys/wrt54g
You will see that depending on the hardware revision things are sometimes not possible but by any means they have banned the hardware and they still deliver if possible a minimal system.
I would prefer to somewhat a more community oriented decision asking, talking, and get the feedback from the Radiusdesk community if whether or not a particular hardware could run MESHDesk.
If possible if you could commit on sourceforge the needed material to compile the tp link tl 841n V11 it would be very helpful rather than reinventing the wheel and throwing away your hard work. That way we will provide feedback whether or not MESHdesk is still able to run. We can even help to enlarge the qualified hardware.
Xavier
Thanks
Last edit: Xavier 2017-02-19
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi All,
I noticed that recenly firmwares for the low end configuration have been dropped. This forum contains a few post where people are looking for them. I'm talking about 4M Flash and 32 RAM.
According to this page:
http://www.radiusdesk.com/docuwiki/user_guide/md_supported_hardware
The decision has been taken recently based on the following LEDE discussion:
https://forum.lede-project.org/t/should-lede-support-devices-with-only-4mb-flash/1018
It sounds to me that the LEDE project made an advise but didn't drop anything.
If you refer to the famous WRT54GL who is still sold:
https://wiki.openwrt.org/toh/linksys/wrt54g
You will see that depending on the hardware revision things are sometimes not possible but by any means they have banned the hardware and they still deliver if possible a minimal system.
I would prefer to somewhat a more community oriented decision asking, talking, and get the feedback from the Radiusdesk community if whether or not a particular hardware could run MESHDesk.
If possible if you could commit on sourceforge the needed material to compile the tp link tl 841n V11 it would be very helpful rather than reinventing the wheel and throwing away your hard work. That way we will provide feedback whether or not MESHdesk is still able to run. We can even help to enlarge the qualified hardware.
Xavier
Thanks
Last edit: Xavier 2017-02-19
is it possible for any user to post the download link of the tplink firmware if possible ?
Hi,
See this thread for firmware https://sourceforge.net/p/radiusdesk/discussion/meshdeskhelp/thread/c428f79a/