I'm trying to build OpenWrt with MeshDesk package on RB411.
I'm aware that's only 4M Ram, but without some packages it's fits to my RB.
Nevertheless, after compiling system with MEshDesk, always have the same problem, system starts gets their IP but after a while I got
[ 102.030000] device eth0 left promiscuous mode [ 102.040000] br-lan: port 1(eth0) entered disabled state [ 102.050000] eth0: link down [ 102.050000] IPv6: ADDRCONF(NETDEVUP): eth0: link is not ready [ 105.970000] reboot: Restarting system
without Meshdesk everything is ok.. no restarts..
It does not matter if I compile openwrt or LEDE, the problem is the same.. I suspect some misconfiguration in Meshdesk package...
Any sugestions?
regards
Michael
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm trying to build OpenWrt with MeshDesk package on RB411.
I'm aware that's only 4M Ram, but without some packages it's fits to my RB.
Nevertheless, after compiling system with MEshDesk, always have the same problem, system starts gets their IP but after a while I got
[ 102.030000] device eth0 left promiscuous mode
[ 102.040000] br-lan: port 1(eth0) entered disabled state
[ 102.050000] eth0: link down
[ 102.050000] IPv6: ADDRCONF(NETDEVUP): eth0: link is not ready
[ 105.970000] reboot: Restarting system
without Meshdesk everything is ok.. no restarts..
It does not matter if I compile openwrt or LEDE, the problem is the same.. I suspect some misconfiguration in Meshdesk package...
Any sugestions?
regards
Michael