How Back to original firmware of Tp-link

[AMJID BASHIR]

Hi All ,

Any one please tell me How return Back to original firmware of Tp-link . I flased 30 TPLINK with meshdesk and work perfectly no issue . But some Devices i want to return back orignal Firmware . How can i do and what is the IP.

[Dirk van der Walt]

Hi,

These days many TP-Link models can be flashed using TFTP

https://wiki.openwrt.org/toh/tp-link/tl-wdr4300#flashing_via_tftp

Check if those hardware you want to revert supports it.

Regards

[AMJID BASHIR]

Hi Dirk ,

What is the IP address of Meshdesk flashed AP .

[AMJID BASHIR]

My AP Lestening 192.168.255.200 IP address problem is Router webpage is not opening and IP pingng is not stable after 4 to five second AP show unreachable and i cannot make SSH properly .Any Solution that work for me .

Thanks

[Zvezdelin Borisov]

Hi,
Meshdesk firmware does not provide web management interface installed by default. In case you really need web management - install Luci.
Follow the instructions - https://wiki.openwrt.org/doc/howto/luci.essentials

Potential problem - if you have no enough space (depends on your hardware - if you use device with 4MB flash - there is no enough space) on root file system - Luci will not install.

The second problem - unstable ping - Aside from cable problems (check!) - the other possible reasons are:
- The access point reboots - unlikely, you may look at LEDs to check.
- Meanwhile the access point obtains different IP address via dhcp - check the server logs to understand the new IP or connect your PC (without active dhcp server) directly to the access point.

If you just want to replace meshdesk firmware with original one - just follow the instactions how to do this via TFTP. There is no need to setup web interface and so on.

Best!
Zvezdelin