From: Stefan J. <st...@gr...> - 2006-06-21 12:50:00
|
Am Mi, 21.06.2006, 14:25, schrieb Christopher Ede: > hello stefan! hi christopher, > thanx for your quick reply; as for the the crash with the > table, well than it might be just the set of libraries i am using; as gdb > shows me that the last methods called before the crash are from QT so i > guess the problem has to be somewere else; as i can not drop by at your > office with my notebook ;o) i guees that one is just bad luck for me :o( > thanx anyhow; Hm, probably. Here (in office) I use the windoof version. But I'll give it a try at home (Debian box)... > as for the updating of the diagramms i included the .dpl perhaps you can > gain some informations from them; thanx again for your friendly help! So I copied the file to an existing project. Then I simulated once. Qucs switched to the dpl. I see 2 diagrams, one with a single curve and one with two of them. Then I switched back (pressed F4). I modified the resistor R1 to read R=1 (changed it directly on schematic). Then pressed F2 (to re-simulate) and again Qucs switches to the dpl and now I saw the curves in both diagrams changed (vout at least :-) I press F4 again and the diagram on the schematic changed as well... So I cant reproduce the problem? Or did I misunderstand something? Cheers, Stefan. |