From: Günther H. <ghu...@gm...> - 2010-01-23 12:59:11
|
Thank you very much for bringing out this wonderful software, but in the schematic editor when two line are crossing there is no diffrence when the are connected or not connected. On the other hand the pictures in the tutorial show a dot for a connection. For my oppinion the readebility of the schematic would improve a lot, if you could see if there is a connection between two lines or not. Thank you very much Guenther Huettemann -- Haiti-Nothilfe! Helfen Sie per SMS: Sende UIHAITI an die Nummer 81190. Von 5 Euro je SMS (zzgl. SMS-Gebühr) gehen 4,83 Euro an UNICEF. |
From: Stefan J. <st...@gr...> - 2010-03-04 14:46:32
|
Am Sa, 23.01.2010, 13:58 schrieb "Günther Hüttemann": Hello Günther, > Thank you very much for bringing out this wonderful software, but in the > schematic editor when two line are crossing there is no diffrence when the > are connected or not connected. On the other hand the pictures in the > tutorial show a dot for a connection. > For my oppinion the readebility of the schematic would improve a lot, if > you could see if there is a connection between two lines or not. Real connections at wire crossing are always visulaized using a dot. If there is no dot, then crossing lines are not connected. Best regards, Stefan. |