#223 Simulation with diode end with error

[Michal Opocensky]

Hello,
this is very simplified case of what I need to simulate, but simulation ends with error. (netlist below)
I do not see any reason why. When I remove diode the simulation runs fine.
Any suggestion what to do?

Best regards,
Michal Opocensky

Idc:I1 _net0 gnd I="1 mA"
IProbe:Pr1 _net0 _net1
OpAmp:OP1 _net2 _net3 _net2 G="1e6" Umax="20 V"
R:R1 _net2 gnd R="5k Ohm" Temp="26.85" Tc1="0.0" Tc2="0.0" Tnom="26.85"
.DC:DC1 Temp="26.85" reltol="0.001" abstol="1 pA" vntol="1 uV" saveOPs="no" MaxIter="150" saveAll="no" convHelper="none" Solver="CroutLU"
Diode:D1 _net4 _net1 Is="1e-15 A" N="1" Cj0="10 fF" M="0.5" Vj="0.7 V" Fc="0.5" Cp="0.0 fF" Isr="0.0" Nr="2.0" Rs="0.0 Ohm" Tt="0.0 ps" Ikf="0" Kf="0.0" Af="1.0" Ffe="1.0" Bv="0" Ibv="1 mA" Temp="26.85" Xti="3.0" Eg="1.11" Tbv="0.0" Trs="0.0" Ttt1="0.0" Ttt2="0.0" Tm1="0.0" Tm2="0.0" Tnom="26.85" Area="1.0"
R:R2 _net1 _net3 R="50 Ohm" Temp="26.85" Tc1="0.0" Tc2="0.0" Tnom="26.85"
R:R3 gnd _net4 R="50 Ohm" Temp="26.85" Tc1="0.0" Tc2="0.0" Tnom="26.85"