Wondered if any other users had this issue. I'm running a Mac using OS X Mavericks (10.9.2). I've found that sometimes I'll go into the virtual console and wont be able to make a selection (the buttons will flash but they wont stay on). I have this problem unless i CMD tab away from QLC+, and then tab back to it. Changing tasks using the dock doesn't seem to help.
Anyone else?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have experienced a similar, but not identical problem. Whenever I press a button that is in toggle mode the first time after opening a particular project, it lights up with the green border, but according to the output monitor does nothing. Whenever I turn the button off and back on however, it works fine. So I always have to use the button twice before it works.
I have not found a fix so far and it seems to be doing this in every project. I'm running QLC+ 4.7.0RC1 in Windows 7.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi guys! I have exactly the same problem as you both (flashing buttons without selection, and need to clic twice a button to turn it off in my BCF2000)! Did you find a solution???? Thx!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Wondered if any other users had this issue. I'm running a Mac using OS X Mavericks (10.9.2). I've found that sometimes I'll go into the virtual console and wont be able to make a selection (the buttons will flash but they wont stay on). I have this problem unless i CMD tab away from QLC+, and then tab back to it. Changing tasks using the dock doesn't seem to help.
Anyone else?
I have experienced a similar, but not identical problem. Whenever I press a button that is in toggle mode the first time after opening a particular project, it lights up with the green border, but according to the output monitor does nothing. Whenever I turn the button off and back on however, it works fine. So I always have to use the button twice before it works.
I have not found a fix so far and it seems to be doing this in every project. I'm running QLC+ 4.7.0RC1 in Windows 7.
Hi guys! I have exactly the same problem as you both (flashing buttons without selection, and need to clic twice a button to turn it off in my BCF2000)! Did you find a solution???? Thx!
you need to edit the bcf2000 and say it NO TOOGLE.
Push the EDIT button of the BCF-> in the same time your selected button-> turn to the left the 6th knob from the left "tNO"-> exit
Don't forget to store you bcf -> twice store!
Now it works well!
Adeline