I'm trying to create a new profile for a LEDJ Par 56 can. But to no avail.
although its a 4 channel fixture, each time i create one, it only comes up with one channel. http://prolight.co.uk/images/media/LEDJ31/LEDJ31-um0.pdf
any tips?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Boxy, thanks for that one.
I just had a look against the one i done, and looks like i got it completely wrong, mine was not saving anything and when it was it was only on one channel.
Thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm currently stuck on my other one now, i know these are basic steps to set up but i'm finding it really hard.
Ive got a DMX decoder which is one of those decoder to RGB strip lighting types, now the unit itself is only a 3 channel unit each controlling one channel of 0-256 values, but can't figure it out. ;-(
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
There are tutorial videos on utube that should explain most of it. QLC+ is very much a layered program in that the 'things' you do are built up with the basics first. In case of the fixture editor, channels then modes etc. You must give everything a name at the top too.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
QLC+ 4.8.2 On A Mac.
I'm trying to create a new profile for a LEDJ Par 56 can. But to no avail.
although its a 4 channel fixture, each time i create one, it only comes up with one channel.
http://prolight.co.uk/images/media/LEDJ31/LEDJ31-um0.pdf
any tips?
If you share the fixture definition maybe.......................
Crappy manual didn't list power consumption :P
Boxy, thanks for that one.
I just had a look against the one i done, and looks like i got it completely wrong, mine was not saving anything and when it was it was only on one channel.
Thanks.
Gotta remember to build in the Mode tab... all of the different channel configs..
I'm currently stuck on my other one now, i know these are basic steps to set up but i'm finding it really hard.
Ive got a DMX decoder which is one of those decoder to RGB strip lighting types, now the unit itself is only a 3 channel unit each controlling one channel of 0-256 values, but can't figure it out. ;-(
With a bit of trial and error, and keep looking at some of the tutorials i'm making some progress
There are tutorial videos on utube that should explain most of it. QLC+ is very much a layered program in that the 'things' you do are built up with the basics first. In case of the fixture editor, channels then modes etc. You must give everything a name at the top too.