Free Virtual Midi controller interface to control some features
Brought to you by:
mcallegari79
Menu
▾
▴
Check this out:
While going through the internet I found this article which works with QLC+ which may be of interest to some of you.
Description
Fergo JoystickMIDI it is a virtual MIDI interface where you can send MIDI commands to any device connected to the computer using a game controller. At the current release, Fergo Joystick MIDI can send MIDI commands (CC, NoteOn and NoteOff) and virtual key presses from any game controller connected to the computer or over a network. You can also use multiple controllers at the same time.
Current version: 1.0.48 (August 3rd, 2010)
Features
Send MIDI commands and virtual keystrokes using game controllers
Support multiple game controllers at the same time
Up to 6 axis and 32 buttons per controller
Send commands through a network
Create presets to save different setups
Controller axis and buttons monitoring
Send three different types of MIDI messages (Note On, Note Off and Control Change)
Configure note, channel and value/velocity range
Customize and calibrate axis maximum and minimum values
Send virtual key presses, including modifier keys like CTRL, ALT and SHIFT
Toggle joystick buttons
Configure the refresh rate to save system resources
Tray support (NEW!)
See the history of all events
Small size and no installation required
100% Free
check this site - http://www.fergonez.net/index.php?lang=en&page=apps&pid=14
Hi Sevito, thanks for sharing this information.
I'll check it out when I have some time.
This is quite a nice piece of software :)
I have tried this software but could not get it to go into the add mode. I found another this http://www.howtogeek.com/79988/turn-a-gamepad-into-a-midi-controller-to-use-with-audio-software/ - I got this to work (interface is a bit clumsy).
Buttons work OK but since the joystick is spring loaded and centred it is not that useful to control an XY pad. See separate post about some suggestions.
Just curious, what do you mean by "add mode"?
I can get the software up and it reads my game controller fine. I cannot seem to add mappings. The add button on the screen remains greyed out. I suspect that it waits for the midi chain to work properly but I could not get it to work.