Just tried to install the shiny new V0.90 on my Macbook, running OSX 10.7.4 (64 bit). The configure seemed to work fine. The make gave these messages right at the end :
ld: warning: ignoring file /opt/local/lib/libkpathsea.a, file was built for archive which is not the architecture being linked (x86_64)
Undefined symbols for architecture x86_64:
"_kpse_set_program_name", referenced from:
_ppl_kpse_wrap_init in kpse_wrap.o
"_kpse_find_file", referenced from:
_ppl_kpse_wrap_find_pfa in kpse_wrap.o
_ppl_kpse_wrap_find_pfb in kpse_wrap.o
_ppl_kpse_wrap_find_tfm in kpse_wrap.o
ld: symbol(s) not found for architecture x86_64
clang: error: linker command failed with exit code 1 (use -v to see invocation)
make: *** Error 1
./bin/pyxplot then failed, as there is no such file.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Just tried to install the shiny new V0.90 on my Macbook, running OSX 10.7.4 (64 bit). The configure seemed to work fine. The make gave these messages right at the end :
ld: warning: ignoring file /opt/local/lib/libkpathsea.a, file was built for archive which is not the architecture being linked (x86_64)
Undefined symbols for architecture x86_64:
"_kpse_set_program_name", referenced from:
_ppl_kpse_wrap_init in kpse_wrap.o
"_kpse_find_file", referenced from:
_ppl_kpse_wrap_find_pfa in kpse_wrap.o
_ppl_kpse_wrap_find_pfb in kpse_wrap.o
_ppl_kpse_wrap_find_tfm in kpse_wrap.o
ld: symbol(s) not found for architecture x86_64
clang: error: linker command failed with exit code 1 (use -v to see invocation)
make: *** Error 1
./bin/pyxplot then failed, as there is no such file.