Re: [PyMca] [PUB] Inquiry Regarding Disabled Peaks in PyMCA Fitting

[PyMca g. p. m. list. <pym...@li...>]

Hello,

Do you have an energy of the incoming photons in your configuration 
(Advanced Fit/Configure/Beam tab) ? If that energy is below 18.04800 
keV, then K and L lines cannot be selected because Rn cannot be ionized 
on those shells but L, L2, L3 and M remain accessible.

Best regards,

Jean

Le 16/12/2024 à 16:23, PyMca general purpose mailing list. a écrit :
> Dear PyMCA Experts,
>
> I hope this message finds you well.
>
> I am currently working on XRF data analysis using PyMCA and have 
> encountered an issue that I hope you could help me with. Specifically, 
> I've noticed that some peaks in the fitting part of the software are 
> disabled. For example, in the case of Rn, peaks such as K, Ka, Kb, and 
> L1 are disabled, whereas L, L1, and L3 are enabled. However, the Peak 
> Identifier estimates the presence of the Rn Ka line.
>
> Any assistance or advice on this matter would be greatly appreciated. 
> Thank you in advance for your time and support.
>
> Best regards,
>
>
> Mohammad Rezaei Pandari
> Ph.D. in Photonics
> Gmail: rez...@gm...
>
>
>
> Mailsuite 	Sent with Mailsuite  · Unsubscribe 
> <https://mailsuite.com/en/privacy/opt-out/unsubscribe/d189afe23b01239e83c3d751ce8682f5a237374b/92ac6a0ab4c48fe871201576ec651d9f03c1e0480abdeccf70f0daeeb1bf883bd8d211e0127f13385948c75fe7e36943675fd5de47aa107130ed2111755619b8>
> 	۰۳/۰۹/۲۶, ۱۸:۵۲:۵۱
>
>
>
> _______________________________________________
> PyMca-users mailing list
> PyM...@li...
> https://lists.sourceforge.net/lists/listinfo/pymca-users