hi thanks for this great project. but i got some issues with 1.0.0.0
if no config file exists:
On first start the board-calibration is running, but no SectionKeys are stored in file;
on second start of pydart got only serialconnection error
if config file from 0.9 exists:
every start works fine, the SectionKeys binding are not correct
could i start the board-calibration with an existing config file?
someone got the same issues?
i got an 7x14 board with arduino mega
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Could you try this version (attached to this message) ?
During the calibration wizard, don't forget to the end even if you don't have any available button. Do not press "enter" at the end or no file will be created. Press space instead if you do not use buttons.
Cheers
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hi thanks for this great project. but i got some issues with 1.0.0.0
if no config file exists:
On first start the board-calibration is running, but no SectionKeys are stored in file;
on second start of pydart got only serialconnection error
if config file from 0.9 exists:
every start works fine, the SectionKeys binding are not correct
could i start the board-calibration with an existing config file?
someone got the same issues?
Hi !
Could you try this version (attached to this message) ?
During the calibration wizard, don't forget to the end even if you don't have any available button. Do not press "enter" at the end or no file will be created. Press space instead if you do not use buttons.
Cheers
Goog Morning!!
Thanks a lot the patched Version worked for me.
Greetz
Great !
I think there was still a bug in the first-use process which decide.
I'll update the 1.0.0 release with this patch ASAP.
Enjoy and don't forget to post a picture of your board !
Poilou
Hi !
The whole download section has been updated with the patched version.
What's up with your board ?
Cheers :)